test the motor by turning the planer on and allowing it to
reach full speed. If the planer sounds excessively loud or
has excessive vibration, turn off the machine immediately
and check again for any loose hardware, retightening any
you may find.
WARNING:
To avoid serious personal injury, do not stand directly
in line with the front or rear of the planer. If an object is
thrown from the planer, it will travel in this direction.
Stand to one side of the planer infeed area.
Turn switch ON ( l ).
Lift the work to the table by grasping the edges of the
board at approximately the middle of the length. Rest the
OPERATION
board end on the feed table and direct the board into the
planer.
NOTE: Boards longer than 24 in. should have additional
support from free-standing material stands.
Push slightly on the board and allow the automatic feed
to take the board.
Release the board to allow the automatic feed to function
properly. Do not push or pull on the workpiece.
Move to one side at the rear of the planer and receive
the planed lumber by grasping it in the same manner as
it was fed. Do not grasp any portion of the board which
has not gone past the outfeed area of the table.
Page 14 — English