Publicidad
EN
BA1400T:
BA2240T:
BA2242T:
Battery
BA2800T:
weight
BA3360T:
BA4200T:
BA5600T:
BA6720T:
CH2100E
Matched
CH3200E
Charger
CH5500E
CH7000E
* Below tools must be used with either BH1000 or
BHX1000 harness when the battery weight more than 3kg.
BCA1200
STA1500
RTA2300
ST1400E-ST
DESCRIPTION
KNOW YOUR LITHIUM-ION BATTERY PACK (Fig. A)
1.
Cooling Air Port
2.
Positive Contact
3.
Negative Contact
4.
Power Button
5.
5-LED Indicator
OPERATION
5-LED INDICATOR ON BATTERY PACK
This lithium-ion battery pack is equipped with a 5-LED
indicator, press the power button to display the charge
level or its working condition, the LED indicator will be
illuminated for 10 seconds
Battery charge
5-LED
level/Working
indicator
condition
80% ≤ Charge
level ≤ 100%
60% ≤ Charge
level <80%
40% ≤ Charge
level < 60%
20% ≤ Charge
level < 40%
6
56 VOLT BATTERY — BA1400T/BA2240T/BA2242T/BA2800T/BA3360T/BA4200T/BA5600T/BA6720T
1.30 kg
1.90 kg
2.20 kg
2.25 kg
2.92 kg
2.90 kg
3.50 kg
3.65 kg
Remarks
5-LED shining green
4-LED shining green
3-LED shining green
2-LED shining green
10% ≤ Charge
level < 20%
Charge level <
10%
Low voltage
Over
temperature
Self
-
maintenance
BATTERY PROTECTION
The battery circuitry protects the battery pack from extreme
temperature, over-discharge, and over-charge. To protect
the battery from damage and prolong its life, the battery
pack circuitry will turn off the battery pack if it becomes
overloaded or if the temperature becomes too high during
use. This may happen in extremely high torque, binding,
and stalling situations. The battery pack will shut down with
power indicator shinning red for 10s when its operating
temperature exceeds 70°C, and will begin normal operation
when it returns to 67°C.
Notice: A significantly reduced run time after fully charging
the battery pack indicates that the batteries are near the end
of their usable life and must be replaced.
1-LED shining green
1-LED flashing red.
5-LED flashing red.
The battery pack is nearly
depleted and needs to be
charged immediately.
5-LED shining red.
Cool the batter pack until
the temperature drops
below 67°C.
For BA1400T/BA2242T/
BA2800T/BA3360T/
BA4200T/BA5600T/
BA6720T 5 LEDs shine
solid red for 10 seconds,
then go out and remain
off for 10 seconds,
then shine solid red for
10 seconds again or 5
LEDs flash green every
two seconds based on
different battery version.
Both indications, the LEDs
will run the cycle until
the self-maintenance is
finished.
For BA2240T no special
indicator.
Publicidad
