Power Stroke PSL0B181 Manual Del Operador página 5

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Polishing and buffing cars, boats, RVs, personal watercraft,
motorcycles, hardwood floors, and large furniture
TURNING THE BUFFER / POLISHER ON/OFF
See Figure 1, page 8.
 To start the buffer/polisher, place the power switch in the
ON ( l ) position.
 To stop the buffer/polisher, place the power switch in
the OFF ( O ) position.
The tool's rotating base moves in random orbital motion.
The orbit diameter is 3/8 in.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF ( O ) position when
not in use or carrying at your side, when installing or re-
moving the battery pack, and when installing or removing
accessories.
TO INSTALL / REMOVE BATTERY PACK
See Figure 2, page 8.
 To install: Make sure the power switch is in the OFF ( O )
position.
 Place the battery pack in the tool.
 Make sure the latches on each side of the battery pack
snap in place and the battery pack is secured in the tool
before beginning operation.
 To remove: Turn the switch off and depress the latches.
OPERATION
PREPARE THE SURFACE
For best results, the surface should be clean and dry. Most
high-gloss surfaces can be cleaned with a mild soap and
water solution. For removal of stubborn dirt such as road
tar, grease, and bug stains, you can use a mild ammonia
solution such as that used in glass cleaners. Before using
any cleaning product, check the label for recommended
applications and follow the directions for use.
Never apply cleaner directly onto surface to be polished.
Apply to a clean cloth then use the cloth to clean the surface.
Do not use any type of abrasive cleanser as it may damage
or scratch the surface.
I NS TA L L I N G / R E M O V I N G A P P L I CAT I O N
BONNET
See Figure 3, page 8.
The reusable application bonnet is made of 100% terry cloth
and is used to apply polish to the painted surface.
 To install: Place the power switch in the OFF ( O ) posi-
tion.
 Remove battery pack from the tool.
 Slip application bonnet edges over the top of the foam
pad.
 Carefully tighten the drawstring around the pad and secure
it with a double-tied bow knot.
 Tuck the knot and the drawstring completely inside the
bonnet.
WARNING:
The drawstring must be tucked securely inside the bon-
net before turning the buffer/polisher on. Failure to do
so could result in the drawstring being caught between
the motor housing and orbiting pad, increasing the risk
of serious personal injury.
 To remove: untie bonnet strings and pull bonnet edges
over and off pad.
APPLYING POLISH TO THE APPLICATION
BONNET
Most polishes are either in paste or liquid form. Before using
any polish, read all directions on appropriate applications
and proper use.
Page 5 — English