Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
•
If the status LED shows blinks GREEN, the battery
pack is good.
•
If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
6.2
EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6 ˚C and 40˚C .
If you put the battery pack into the charger in warm or hot
environment, the charger LED light is red. Pull out the
battery pack and let the battery cool for approximately 30
minutes.
6.3
WALL MOUNTING THE
CHARGER (CH60R00 ONLY)
1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood
studs.
3. Drill two paralleled holes 4.5" (114.3 mm) on center.
4. Use wall anchors and screws to attach the charger to the
drywall.
For charger: CH60R00
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
WARNING
NOTE
English
7
MAINTENANCE
7.1
CLEAN THE MACHINE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or put the air flow in water.
•
Clear the unwanted material out of the air vent with a
vacuum.
•
Clean housing and the plastic components with a dry and
soft cloth.
Do not use strong solvents or detergents on the plastic
housing or components.
7.2
STOW THE MACHINE
•
Remove the battery pack before you store the charger or
disconnect the charger.
8
TROUBLESHOOTING
PROBLEM
Charger doesn't
work. Charger
shows defective
mode. (LED
flashes Red)
Charger doesn't
work. Charger
shows evaluation
mode (LED indi-
cates Red solid
ON).
9
TECHNICAL DATA
Model
CAC801
Voltage
60 V
Input
120V AC 50/60Hz, 2.5A Max
Output
60V DC 3A
6
NOTE
IMPORTANT
POSSIBLE
SOLUTION
CAUSE
Try to remove and
reinsert the battery
pack in the charg-
er.
Battery pack or
Try charging a dif-
charger is defective
ferent battery
or there is a bad
pack.
connection be-
tween the battery
Unplug the charg-
pack and charger.
er and wait until
the red LED goes
out, then reconnect
the plug to the
power supply.
Allow the battery
pack to reach nor-
mal temperature.
Battery pack is ei-
Charging will be-
ther too hot, or too
gin when the bat-
cold.
tery pack returns
to 3°C-47°C
(37°F-117°F).
Publicidad
