monzana Julelys MZPL42 Manual De Instrucciones página 6

WARNING! Do not tighten the screws completely until the product
has been fully assembled. If you do tighten them completely at an
early stage, significant problems could occur during the further
assembly of the product.
Maintenance and care
Tu Turn off the lamp, remove the batteries and allow the light bulb/lamp to cool completely. Only wipe
them with a damp cloth. Clean the lamp without aggressive cleaning agents, cleaning alcohol or other
chemical solutions. This can damage the case or even affect its function. Replace the batteries of the
remote control as soon as the lights no longer respond to its commands. Replace the batteries of the
lamps as soon as the luminosity decreases considerably. The LEDs are permanently installed and
cannot be replaced.rn off the lamp and allow it to cool down completely. Do not use a spray hose to
clean the lamp. Wipe them off only with a damp cloth. Only clean the lamp when the plug is
unplugged.
Commissioning
Light
Open the back of the lamp by turning it counterclockwise to insert 3xAAA batteries (not
1.
included). Insert the batteries with the correct polarity.
2. Replace the cover and turn it clockwise.
Remote control
1. Pull the plastic security label from the remote control
2. The remote control is directly operational
Use
1. Switch the chain of lights on and off permanently using the On/Off switch on the remote
control.
2. You can choose between the following modes:
a. Combination
b. Wavy
c. Section by section
d. Slo Glo
e. Lightning
f. Fading slowly
g. Sparkling
3. With the "TIMER" button you can switch on the light chain for 6 hours. The lights turn off after
6 hours and turn on again automatically after another 18 hours.
4. You can continuously adjust the brightness with the "+" and "-" buttons.
MANUEL D'UTILISATION
Généralités
6