Publicidad
Section 7
MAINTENANCE CHART - RECOMMENDED SERvICE INTERvALS (CONT'D)
HOURS
BREAK-IN
8
(FIRST 10)
7.2
LUBRICATION
GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)
LOCATION
1 Caster Wheel Pivot *
2 Caster Wheel Bearings
3 Brake Actuator
4 Cutter Deck Bellcrank
5 Cutter Deck Pusharms
6 PTO Spindle
7 Cutter Deck Spindle
8 Brake Handle
9 Cutter Deck Drive Shaft
+ Compatible Greases:
* Remove plug and insert grease zerk. Before filling with grease, remove dust cap from the top of the pivot.
40
100
200
500
X
X
X
X
X
X
X
X
X
LUBRICATION INTERvAL
500 Hours/Yearly
100 Hours/Monthly
200 Hours/Monthly
40 Hours/Weekly
100 Hours/Monthly
40 Hours/Weekly
40 Hours/Weekly
200 Hours/Monthly
40 Hours/Weekly
Mobilix #2 found at Mobil Service Stations
Ronex MP found at Exxon Service Stations
Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
Shell Alvania #2 found at Shell Service Stations
Lidok EP #2 found at industrial shops
PROCEDURE
Apply grease to fittings
Check hardware for tightness
Change engine oil filter
Check hydraulic oil level
Replace engine fuel filter
Drain hydraulic system and
replace hydraulic oil
Replace hydraulic oil filter
Replace cutter deck gearbox
lubricant
Change coolant
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
+Lithium MP White Grease 2125
+Lithium MP White Grease 2125
Chassis Grease
Chassis Grease
31
COMMENTS
See paragraph 7.2
See paragraph 7.4
See paragraph 7.3
See paragraph 7.5
Use SAE 20W50 Motor Oil.
See paragraph 7.3
See paragraph 7.3
See paragraph 7.11
See paragraph 7.12
LUBRICANT
R
NO. OF
PLACES
2
2
2
4
2
1
3
1
3
Publicidad
