Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Light Kit
and Glass Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
THE GLASS IS FRAGILE, USE CARE WHEN
INSTALLING THE LIGHT KIT AND THE GLASS
SHADE.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 13)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads fit into the keyhole slots. Turn the
light kit pan clockwise, tighten the screws.
Re-install the screw that was removed in
step 1 and tighten firmly.(Figure 13)
3. Remove one screw from the light kit pan
and loosen, but do not remove, the other
two screws. Connect the wires from the
light kit assembly to the wires from the fan
motor assembly by connecting the molded
adaptor plugs together. Carefully tuck
all wires and splices into the switch cap.
(Figure 14)
4. Push the light kit assembly up so that
the two loosened screw heads fit into the
keyhole slots. Turn the light kit assembly
clockwise, tighten the screws. Reinstall
the screw that was removed in step 3 and
tighten firmly. (Figure 15)
5. Place the glass shade into the light kit
pan, aligning the three flat areas on the
top of the glass shade with the three raised
dimples in the light kit pan. Turn the glass
shade clockwise until it stops. (Figure 15)
PERIODICALLY CHECK THE SHADE IS SEATED
FULLY CLOCKWISE IN THE LIGHT KIT PAN
ASSEMBLY
Light Kit
Adapter
Light Kit
Assembly
Mounting
Screw (3)
Light Kit
Assembly
Blue
Black
LED
Module
Raised
Dimples
Glass
Figure 13
White
Molded
Adaptor Plugs
White
Mounting
Screw (3)
Figure 14
Light Kit
Assembly
Flat Area
Figure 15
8.
Publicidad
