YATO YG-03012 Instrucciones De Uso página 10

Connect the product to power supply according to instructions in this manual.
If it is possible, select the rotational speed adapted to the agitator attached and food products being mixed. Subsequent speeds
are marked with numbers, the higher the number the higher the speed, according to technical specifi cation.
Start the product with the switch.
After the work is fi nished, stop the product by pressing the switch. Unplug the power cord from the mains socket. Wait until all
moving parts have stopped, then open the bowl cover, raise the agitator and carefully unlock the bowl and remove it from the
product base.
Note! Observe the product throughout the entire work cycle. If you notice any signs of abnormal operation, e.g. suspicious sounds,
increased noise, increased vibrations or a sense of suspicious smell, immediately switch off the product by pressing the switch,
disconnect the plug from the power socket, wait until all moving parts have stopped and only then try to locate the failure.
Product maintenance
NOTE! Prior to each cleaning switch off the product, unplug the power cord from the outlet, wait until it has cooled down, and then
start the maintenance procedures.
NOTE! It is recommended to clean the agitator and the inside of bowl immediately after work is fi nished. This will prevent the food
remains from drying up and facilitate product cleaning.
If the bowl and agitators are dismantled from the product, they must be removed for maintenance operations.
The dismantled agitator and bowl can be cleaned under the stream of running water.
If, while working, the drive housing becomes soiled with processed food, stop the work, disconnect the product from power supply
by pulling the plug of the power cable from the power socket, clean the product and then resume work.
Only mild detergents designed for cleaning kitchen utensils may be used for cleaning the product. It is forbidden to use abrasive
cleaning agents e.g. powder or cleaning milk and any cleaning agents that contain caustic agents. Do not use gasoline or alcohol
solvents for cleaning.
Cleaning agent should be dissolved in water according to information supplied with it, then apply it on a soft cloth and clean the
drive housing from the outside.
Remove residues of the cleaning agent with a soft cloth slightly soaked in clean water. Then dry all surfaces with a dry soft cloth.
NOTE! The drive housing is not designed for cleaning with a water jet. Also, do not immerse the drive in water.
None of the product component is suitable for washing in a dishwasher or in a high pressure water jet.
Before using the product again, all components should be thoroughly dried.
After drying, store the bowl in a reversed position. This will prevent impurities from penetrating the inside of the bowl.
Product transport and storage
Before you start to store or transport the product, clean it from food remains.
Product when stored should be kept indoors, protect it from dust, dirt and moisture. It is recommended to store the product in its
original packaging.
TECHNICAL DETAILS
Parameter
Catalogue number
Rated voltage
Rated frequency
Rated power
Insulation class
Max. rotational speed without load
Bowl capacity
Max. bowl load
Net weight
Protection class
Noise level L
wA
O R I G I N A L
10
GB
Measuring unit
[V a.c.]
[Hz]
[W]
[min -1 ]
[l]
[kg]
[kg]
[dB(A)]
I N S T R U C T I O N S
Value
YG-03012
220-240
50/60
350
I
0-780
7
0.4
22
IPX0
<85