Publicidad
Idiomas disponibles
Idiomas disponibles
4. ADJUSTING HEADGEAR (FOUR PARTS)
4.1. Headgear top (see adjustment "W" in the g. 4)
Pressing the adjusting knob located on the back of the headgear and turn left or right to a desired
tightness.
4.3 Headgear tightness (see adjustment "Y" in the g. 4)
Adjusting the distance between the face and the lens by loosening both outside tension knobs and
press inward to free from adjustment slots. Move forward or back to desired position and retighten.
(Both sides must be equally positioned for proper vision.)
4.4 Angle adjustment (see adjustment "X" in the g. 4) Four pins on the right side of the headgear top
provide adjustment for the forward tilt of the helmet. To adjust, loosen the right outside tension
adjustment knob then lift on the control arm tab and move it to the desired position and retighten
tension adjustment knob.
5. AUTO-DARKENING FILTER FUNCTIONS
5.1 Selecting the Operating Mode
For some lters, two modes of operation can be selected: welding or grinding. (See Fig.3)
Grind Mode: shade function is turned o . In this mode the shade is xed in the light state that allowing
a clear view to grind a weld with the helmet providing face protection. Used for metal grinding
applications.
Grind mode is intended for Grinding not for welding. Before restarting welding, the knob should be set
back to the " Weld position"
Fig3
03
SWEISSWELD.COM
Fig4
Publicidad
