5. Replacing the light bulb
• To install/replace the lamp, first unplug the device from the mains outlet.
• Be aware that the housing might become hot during operation – allow enough time for the device
to cool down before touching it.
• Open the front cover by loosing the 4 screws.
• DO NOT TOUCH the bulb with bare fingers – use a piece of cloth or wear gloves.
• Only use bulbs that are suited for this device. Refer to the "Technical Specifications"
below.
• After replacing the bulb, close the front cover firmly with the 4 screws. Make sure that the seal
between cover and housing is still intact and positioned correctly.
• Re-apply mains power to the device.
6. Technical specifications
power supply
power consumption
luminance
cable length
height
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.perel.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced
to any electronic medium or otherwise without the prior written consent of the copyright holder.
23/11/2009
EWL18/EWL19
EWL18
230VAC / 50Hz
300mA / 32-36W
2200 lux
90-165cm
3500g
3
EWL19
600mA / 64-72W
4400 lux
5m
4800g
®
© Velleman
nv