Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Removing the protective caps
□
Remove the protective caps (N). Loosen the
anges (O) from the valve bodys (P & Q). Adjust
the rubber washers (R), metal washers (S) and
mounting nuts (T) to the bottom of valve
bodys (P & Q).
N
O
P
R
S
T
6
Connecting the hoses
□
Connect the hoses (U) to the bottom of the hot
and cold end valves (P & Q), as shown.
□
Align the middle body (F) in a position that will
allow maximum clearance to connect the
hoses (U).
□
Carefully bend the hoses (U) to t in the
available space, and carefully thread the hose
(U) couplings onto the sides of the middle
body (F). Tighten all connections with a wrench.
N
O
Q
R
S
T
5
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
□
From underneath the deck, insert the cold end
valve (Q) with the rubber washer (R), metal
washer (S) and mounting nut (T) through
the hole on the right (cold) side.
□
From above, thread the ange (O) onto the
valve body (Q).
□
Tighten the mounting nut (T) using a basin
wrench, so that the ange (O) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (P)
on the left (hot) side.
P
P
U
5
Please contact 1-855-HD-GLACIER for further assistance.
O
Q
R
S
T
F
Q
U
HOMEDEPOT.COM
Publicidad
