Publicidad
Idiomas disponibles
Idiomas disponibles
• Assure that electrical installation is adequate and in
conformance with National Electrical Code, ANSI/
NFPA 70 - latest edition**, or Canadian Electrical Code,
part 1 C22.1 (latest edition)*** and all local codes and
ordinances.
These shall be carefully followed at all times.
Tools you will need
The following tools are needed to install your new warming
dreawer:
• Tape measure and straightedge or ruler
• Pencil
• Phillips screwdriver
• Level
• Wire cutters and wire stripper
• Hand or saber saw
• 1" (2,5cm) Hole saw
• Drill and drill bit
• Safety gloves and goggles
• Volt meter (0-250VAC)
Packaging
Remove all tape and packaging before using the warming
drawer.
Destroy the packaging after unpacking the drawer following
the rules in force in your town. Never allow children to play
with packaging material.
Power requirements
The warming drawer must be supplied with the proper
voltage and frequency. The drawer is manufactured to be
connected to a three-wire, single phase, 120 Volt, 60 Hz
AC electrical supply.
Choosing drawer location
Carefully select the location where the warming drawer will
be placed.
It should be located for convenient use in the kitchen.
Make sure that electrical power can be provided to the location
selected.
Steps for installation
The following pages provide the necessary information for
proper installation of the appliance and are arranged as
follows:
• Technical Data
• Installation Cutout Dimensions, Required Clearances and
Mounting instructions
• Electrical Supply and Wiring Requirements
• Final Checklist
EN
7
Publicidad
