Danby Designer DWC310BLSDD Manual Del Propietário página 6

Idiomas disponibles

OPERATING INSTRUCTIONS

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for any

length of time during this process, it must be allowed

to remain upright for 6 hours before plugging in to

avoid damage to internal components.

1. Use a screwdriver to remove the hinge cover

and hinge from the right side of the chassis.

Remove the door from the chassis. Remove the

hole covers from the screw holes on the left side

of the chassis and install the upper hinge on the

left side.

2. Install the hole covers in the screw holes on the

right side of the chassis. Move the hole cover on

the top of the door from the left to the right side

to expose the hinge pin hole on the left side of

the door.

3. Remove the screws from the door handle and

move the door handle to the right side of the

door. Pre-drilled screw holes can be found on

the right side of the door.

4. Install the door into the top hinge and then

move the lower hinge from the right side of the

appliance to the left side.

Note: Before tightening the bottom hinge, ensure

that the top of the door is level with the top of the

cabinet and that the rubber gasket is making a

good seal with the cabinet all the way around.