Homelite UT44174 Manual Del Operador página 8

WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
This battery powered grass shear is always in an oper-
ating condition and the blades can move if the switch
trigger and lock-out button are pushed. The bottom
cover latch should always be moved to the unlock (motor
disabled) position when removing cut or jammed material
from the blades, when changing blades or accessories,
when transporting the grass shear, and when the grass
shear is not in use. If the tool is left unattended, remove
the blades and store them in a separate location out of
the reach of children. Failure to follow these instructions
could result in accidental or unauthorized starting of the
grass shear and cause serious personal injury.
WARNING:
Do not allow familiarity with product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
ASSEMBLY
ASSEMBLING THE GRASS SHEAR
See Figure 5.
To unlock bottom cover.
 Slide bottom cover latch to the right
 Pull the bottom cover down to remove.
To install blades:
 Install blades into the hole on the bottom of the shear.
 Place bottom cover slots onto tabs and slide close.
 Slide bottom cover latch left
OPERATION
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 Trimming grass and other light weeds
CHARGING THE GRASS SHEAR
See Figure 2.
This tool has been shipped in a low charge condition to prevent
possible problems. Therefore, you should charge it overnight
prior to use. After each use, charge for at least 10 hours.
To charge:
 Stop the motor.
 Insert charger plug into input jack making sure they are
properly connected.
 Charger can be used with normal household voltage
of 120 volts, AC only, 60 Hz.
 Connect charger to power supply.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
Page 8 — English
.
to lock.