Publicidad
Idiomas disponibles
Idiomas disponibles
39
1/4-20 x 2 1/2 Hex Head Bolt
(Qty. 1)
1/4-20 x3 1/4 Hex Head Bolt
(Qty. 2)
12. Attach end of linkages #4 with two holes to INSIDE of Leg #2 as shown
in Detail G & Detail H. Secure through end hole with screws #23,
locknuts #15 and plastic spacers #31. Tighten hardware snug enough to
keep table stable but do not overtighten. Tubes must pivot freely.
13. On one side of the table attach slotted end of safety strap #6 to
INSIDE of Leg #2 using one bolt #39, one spacer #30, one washer
#24, and one hex nut #15. Tighten hardware until snug but do not
overtighten. Tubes must pivot freely. See Detail H.
14. Attach other end of safety strap #6 to OUTSIDE of linkage #4
using one bolt #9, one washer #24, one spacer #30, and
one hex nut #15 as shown in Detail H.
Important! Do NOT put other safety strap #6 on this
table half. It will be installed on second table half later.
15. Gently tap caster sockets #12 into U-support #7 until
flange on sockets touches the edge of the tube. DO
NOT HIT CASTER SOCKET DIRECTLY WITH A
HAMMER! SET A PIECE OF WOOD ON CASTER
SOCKET AND HIT PIECE OF WOOD TO DRIVE
CASTER SOCKET INTO U-SUPPORT.
16. Insert casters #11 into caster sockets #12.
See Figure 7A.
3/4" Spacer
15
31
(Qty. 2)
1/4" Locknut
(Qty. 3)
5/16" Spacer
30
(Qty. 2)
39
9
23
Detail H
8
24
1/4-20 x 1 1/2 Bolt
9
First Table Top
Figure 7A
Figure 3
Figure 3
2
30
24
15
6
24
4
30
31
15
Plastic Washer
(Qty. 2)
12
7
(Qty. 1)
4
15
4
2
31
Detail G
11
23
Publicidad
