Publicidad
Idiomas disponibles
Idiomas disponibles
MONDIAL DESK FAN 30 and 40 cm
STRUCTURE:
1.
Cable Plug
2.
Pedestal
3.
Base
Vertical Holes
4.
5.
Rear Grid
Guide Pins
6.
7.
Screw Nut
Fan Blades
8.
8
UK
E
FIG. A
Motor Shaft
9.
10.
Fan Blades Button
11.
Front Grille
Guide
12.
13.
Lower Holes
Side Latches
14.
15.
Fastening Bolt
INTRODUCTION
Thank you for trusting in Mondial. To ensure proper operation and maintenance of the product, carefully
read the instructions in this manual and keep it in the event that you may need in the future. We
recommend that you also keep the packaging in case of repairs, and dispose of all plastic bags that
could become dangerous toys for children.
The appliance is very easy to use. Just connect it to the electricity supply socket (220-250V).
If you need more information, please contact Mondial.
Advice:
The use of Mondial appliances by children needs clear instructions of use and constant
supervision during use of the appliance.
OPERATION
The instrument consists of the following parts, see fig.A:
Before using the appliance:
˃
Unpack the appliance.
˃
Clean the appliance. See "Cleaning and Care"
Assembly (See fig.A)
1.
Insert the cable plug (1) coming out of the bottom of the pedestal (2) into the hole of the base
(3) by pulling it out. Using a fixed and plan location, support the base (3) and fit in the pedestal
(2) until it is fixed. Observe the marking for fitting it accordingly in the bottom rear of the
pedestal.
2.
Position the vertical holes (4) of rear grid (5) in the guide pins (6) with the carry handle facing
up. Insert the other nut (7) and rotate clockwise to lock the two parts.
3.
Fit the fan blades (8) onto the motor shaft (9), aligning the flat face of the shaft with the flat face
of the fan blades. Insert the fan blades button (10) and turn counterclockwise to lock the two
parts together.
4.
Position and place the front grille (11) with the guide (12) facing up, aligning the lower holes
(13) of the two parts. With the two grilles aligned, tighten the side latches to (14) the grill in
place. Insert the fastening bolt (15) into the lower holes until the two parts are locked.
Oscillation control
1.
Push the oscillaton knob to oscillate
2.
Pull the oscillation knob to stop.
CLEANING AND CARE
1.
Remove all items of packaging from the fan.
2.
Remove the locking nut from the motor shaft.
3.
Position the rear guard over the motor shaft, ensuring that the notches are correctly aliegned
and then secure with the looking nut.
4.
Align the fan blade with the flat part on the motor shaft and secure by tightening the blade cap
by turning counter-clockwise.
5.
Attach the front guard centre hook to the middle of the rear guard and secure by pushing the
guards together until they click position.
6.
Open the locking clip. The guard bottom nut and screw must also be fitted to ensure secure
fitting.
7.
Always disconnect the cord from the electrical outlet when cleaning your fan.
8.
Light accumulated dust may be removed from the fan with a soft cloth or vacuum cleaner
using the dusting brush attachment.
9.
Wipe the exterior surfaces of the fan occasionally with a cloth moistened (not dripping wet)
UK
E
9
Publicidad
