Greencut PIN660C Manual De Instrucciones página 53

The uneven movement of the pistol gives an uneven surface quality. A uniform movement of the spray gun provides
a uniform surface quality.
If the coating material accumulates in the nozzle (b) and air cap (a). Remove the air cap nut and air cap (a). Clean
both parts and around the nozzle (b) with solvent or water with a stiff brush. If the nozzle (b) is blocked, it can be
removed with a 9 mm open-end wrench, carefully unscrew it from the paint head. Clean nozzle (b) and remove any
accumulated paint. Be careful not to damage the nozzle (b), as this will affect the performance of the gun.
MAINTENANCE
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the machine is completely turned off before performing any maintenance
or repairs. This will eliminate any potential risks.
CLEANING AFTER EACH USE
1. Turn off the device. Open the trigger to bring the spray gun coating
back into the container.
2. Unscrew the container. Return the remaining material to the
material container.
3. Clean container. Remove the suction tube by turning it
counterclockwise and gently pull it away from the paint head.
Disassemble the suction tube for cleaning by turning it clockwise
and pulling to disassemble.
Air cap
a
b
53
EN