Descargar Imprimir esta página

Progress Lighting AirPro P2568-2030K Manual De Instalación página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Hanging the Fan
REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 5)
Step 2. Remove the mounting bracket from
the canopy by removing the 1 of 2 screws
from the bottom of the mounting bracket and
loosening the other one a half turn from the
screw head. Next, turn the canopy counter
clockwise to removing the mounting bracket
from the canopy. (Fig. 5)
Step 3. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 6.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 5. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly.
Step 6. Route wires exiting from the top of
the fan motor through the collar cover,
canopy cover, canopy and then through the
ball / downrod. (Fig. 7)
Step 7. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing (Fig. 7). Carefully insert the hanger pin
through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring inside the
downrod. Insert the locking pin through the hole near
the end of the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 7.
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 7
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 8. Tighten two set screws on top of the fan
motor firmly. (Figure 7)
Step 9. Place the downrod ball into the hanger
bracket socket.
Figure 5
CUL Listed
electrical
box
Ceiling
hanger
bracket
Hook
Figure 6
Motor wires
Ball/downrod
assembly
Ceiling
canopy
Locking pin
Tighten
Ceiling
screws
hanger
firmly
bracket
Ceiling
canopy
Figure 7
Canopy
cover
Washers
Mounting
screws
(supplied with
120V Wires
electrical box)
Pin in locked
position
Canopy cover
Collar cover
Hanger pin
Motor collar
4.

Publicidad

loading

Este manual también es adecuado para:

Airpro p2568