Whirlpool ADN203 C Manual De Instrucciones página 10

2.
Remove the two screws (8) and separate the bottom bracket (10) together with the
washers and gaskets (9) on the small axle.
3.
Remove the two screws (7) and separate the bracket (5) and the gasket (6).
4.
Separate the door (4).
5.
Remove the 4 screws (1) at the top of the advertising panel, separate the top of the
advertising panel (11), remove the front part of the advertising panel (12), and then
remove 4 screws (13) and separate the advertising panel; then loosen the 2 screws (14)
and transfer the upper bracket (15) to the other side. Assemble the advertising panel in
reverse order.
6.
Turn the door 180°, insert the upper axle and mount the door on it.
7.
Remove the mounting screws (2) from the door, separate the handle (3) and attach it by
screwing the screws into the holes on same side.
8.
Using the supplied washers and gaskets, attach the lower bracket (10) on the opposite
side of the cooler, but first attach the bracket axle to the door. Screw in the bracket (5)
on the opposite side of the cooler.
OPERATION PROBLEMS AND THEIR SOLUTIONS
(TROUBLESHOOTING). What if ...
The appliance is plugged in to the mains but it does not work. Check if your house
•
electricity supply installations are in order. Check if the plug is correctly inserted into the
electricity supply socket.
The noise has become louder. Check if the appliance is standing stable, on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching any
furniture and if no part of the refrigeration system at the back part of the appliance body
is touching the wall. Pull the appliance away from any furniture or walls. Check if the
cause of increased noise isn't due to bottles, cans in the appliance that might be touching
each other.
Water has appeared at the bottom of the refrigerator compartment.
•
whether a thaw water channel space isn't blocked. Clean the thaw water channel space
with a cleaner intended for that purpose.
When the appliance door is opened, the rubber sealing gasket pulls out. The
•
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the
groove for it with warm water containing soap or dishwashing detergent and wipe dry.
Put the rubber sealing gasket back into the place.
High temperature in appliance, the compressor operation pauses are short.
•
Ascertain whether the appliance door/doors are shutting tightly, whether the door wasn't
kept open longer than necessary when taking out or putting in foodstuffs or whether a
large amount of warm food was placed in the appliance.
The top of the appliance has condensation on it. The ambient relative air humidity is
•
above 60 %. Ventilate the room where the appliance stands and if possible remove the
cause of the humidity.
IF YOUR APPLIANCE IS NOT WORKING PROPERLY, ASCERTAIN WHETHER YOU CAN
REMEDY THE CAUSE OF THE FAULTY FUNCTIONING OF THE APPLIANCE YOURSELF. If you
cannot solve the problem yourself, contact the nearest refrigerator service representative by
telephone or in writing. When making contact necessarily indicate the refrigerator model and
number. You will find this data on the product label, which is glued to the wall of the
refrigerator compartment.
WARRANTY SERVICE
9
Check