Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGING THE DIRECTION OF THE
DOOR OPENING
Changing the direction of the door opening (Fig. 20)
1.
Before reversing the door opening direction, unplug the appliance and remove
all food.
2.
Using a flat screwdriver pry and remove hinge caps.
3.
Using a Phillips screwdriver remove the door upper hinge while holding the
door (Fig. 20.1).
4.
Using a Phillips screwdriver remove the middle hinge while holding the upper
door*
5.
Set the door aside in a safe place.
6.
Tilt the appliance (up to 40 degrees) so as to have sufficient access to the
lower hinge (Fig. 20.2).
7.
Using a Phillips screwdriver remove lower door hinge
8.
Attach the lower hinge on the other side (Fig. 20.3).
9.
Position the door assembly in such a way so that pin of the lower hinge is
aligned with the appropriate hole of the lower door bracket.
10. Attach the middle hinge on the other side of the appliance so that the lower
pin of the middle hinge is aligned with the appropriate hole of the upper door
bracket. Position the second door assembly so that the upper pin of the mid-
dle hinge is aligned with the appropriate hole of the lower door bracket.*
11. Attach the upper hinge so that the hinge pin is aligned with the appropriate
hole of the upper door bracket.* (Fig. 20.4).
12. Check that doors are properly aligned with the appliance body.
13. Replace the hinge caps.
14. Switch on the appliance as described in the relevant section of its operating
instructions.
* This action applies to appliances with both refrigeration and freezer chambers.
63
Publicidad
