Publicidad
Idiomas disponibles
Idiomas disponibles
8. Screw U-support tube (#21) to Strut Tubes (#17) with two Screws
(#33) as shown in Figure 5. Align holes in U-support with holes
in Strut Tubes and thread screw (#33) into hole in Strut Tube
(#17) Tighten screws all the way but be careful not to over
tighten. You could strip threads on screws if you over tighten.
Note:
Due to shipping requirements the hinge (#18) may be positioned as
shown in Detail A, you will have to rotate the hinge to the position shown
in Detail B. DO NOT unscrew the hinge, you can rotate the hinge
without unscrewing it from the table.
If you want to see a video on how to position hinge (#18) go to:
http://www.escaladesports.com/customer-service/videos.html
9. Attach Hinges (#18) to Strut Tubes (#17) as shown in Figure 5
and Detail B. With hinge positioned as shown, align hole in hinge
with hole in Strut Tube and attach with ¼" Screw (#30), Plastic
Washer (#38) and Locknut (#34). Plastic Washer (#38) goes
between Strut Tube and Hinge. Tighten nut securely. Repeat for
other Hinge. CAUTION: Hinges must be positioned exactly
as shown or table will not operate correctly and could be
damaged.
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
Figure 5
37
Spacer (#37) goes
between Linkage (#16)
and Leg (#19)
24
17
34
16
18
34
19
33
16
30
Plastic Washer goes
38
between Strut Tube
(#17) and Hinge (#18)
17
10. Attach Linkages (#16) to Leg (#19) as shown in
Figure 5. Pivot one Linkage (#16) up and pivot
Leg out from top and align hole in Linkage with
hole in Leg (#19). Attach Linkage (#16) to Leg
(#19) using Hex Head Bolt (#24), Spacer (#37)
and Locknut (#34). Spacer (#37) goes between
Linkage and Leg. Attach other Linkage to Leg the
same way. Tighten nuts securely.
11. Attach Corner Protector (#40) to table corners.
Push snap tabs on Corner Protector into holes in
rails. Be sure that tabs are aligned with
holes before pushing. You could break tabs if
they are not aligned correctly.
12. With at least two adults, repeat steps 7
.
through 11 for other table top assembly.
37
34
19
16
34
21
38
30
18
6
40
ATTENTION: If hinge is positioned as
shown below (Detail A), Rotate the hinge
as shown in Detail B. Do not take the
hinge off the table.
18
24
Shipping position
of hinge
CAUTION: Position hinges exactly as
shown in Detail B or table will not
operate correctly and could be damaged.
Detail B
33
30
18
Assembly
position of hinge
In the correct position
Hinge #18 will look like a
"V" when attached to Strut
Tube (#17).
Detail A
17
34
38
17
Publicidad
