Publicidad
Idiomas disponibles
Idiomas disponibles
Stereo Sound Mode
Stereo Sound Mode
CD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO] repeatedly until the
desired sound mode appears.
STEREO
• Each time you press [AUDIO], the sound mode
changes as example below.
STEREO (stereo sound with left and
right channels)
L-ch
(left channel sound only)
R-ch
(right channel sound only)
Note:
• Virtual surround cannot be changed when the sound mode
is set to either "L-ch" or "R-ch".
Virtual Surround
Virtual Surround
You can enjoy virtual surround on your 2 channel stereo system.
1
During playback, press [MODE] repeatedly until "
appears.
OFF ( SURROUND )
2
[Cursor K / L] to select the sound level.
1
or
1 :
Natural effect.
2 :
Emphasized effect.
OFF : No effects (original sound).
3
Press [BACK] to exit.
Note:
• The setting will be kept even if the unit is turned off.
• For audio CD, virtual surround will not be effective if the
sound mode is set to something other than "STEREO".
Refer to "Stereo Sound Mode" on page 43.
• Turn down the level or select "OFF" if the sound is distorted.
"
( SURROUND )
Español
Marker Setup
Marker Setup
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1
During playback, press [MODE] repeatedly until
"
" / "
" appears.
e.g.) DVD
_ _ /12 (SEARCH)
2
Use [Cursor K / L] repeatedly until marker search
menu appears.
1 2 3 4 5 6 7 8 9 10 AC
or
3
Use [Cursor s / B] to select an available marker within
60 seconds.
1 2 3 4 5 6 7 8 9 10 AC
or
4
When the playback reaches the point at which you
want to set a marker, press [ENTER].
• Marker is now set.
5
Press [BACK] to exit.
To return to the marker later
1
Repeat steps 1-2 in "To set a marker". Use [Cursor s / B]
to select the desired marker.
e.g.) DVD
or
2
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
Note:
• Marker search menu will disappear in about 60 seconds
when there is no input.
• You can mark up to 10 points.
• To clear a marker, select the marker to be cleared, and then
press [CLEAR].
• Ejecting the disc or turning off the power will erase all
markers.
• Selecting "
" at step 3 in the section "To set a marker" will
also erase all markers.
Français
English
2 3 4 5 6 7 8 9 10 AC
2 3 4 5 6 7 8 9 10 AC
2 3 4 5 6 7 8 9 10 AC
EN
43
43
Publicidad
