GE PFW950 Manual Del Propietário página 25

REVERSING THE DOOR SWING (OPTIONAL ON SOME
MODELS ONLY)
REMOVE THE TERMINAL
6
HOLDER AND DISCONNECT THE
PIN CONNECTOR FROM WASHER
• Using your
fingers, pry the
terminal holder
from the washer
face.
• Disconnect the
pin connector.
Terminal Holder
Pin Connector
REMOVE LOCK ASSEMBLY AND
7
INSTALL ON OPPOSITE SIDE OF
WASHER
• Remove the 2 screws from the lock cover plate and
remove it from the washer face.
49-3000217 Rev 6
Installation Instructions
Lock
Cover
Plate
REMOVE LOCK ASSEMBLY AND
7
INSTALL ON OPPOSITE SIDE OF
WASHER (CONTINUED)
• Insert the provided lock bar into the lock mechanism
in the washer face. Remove the lock assembly by
removing its two screws, using the lock bar to lift it up
to unhook, tilting and pulling it out of the washer face.
Disconnect its pin connector by unsnapping its locks.
• Do NOT rotate lock assembly. Move it to the opposite
side of the washer and connect the pin connector making
sure it is fully snap locked together. Tilt and insert
the lock assembly into the washer face, lift it up and
latch its hook into its window. Replace its screws.
Remove the lock bar from the assembly and retain
for future use.
Hook Window
Hook
Replace
Assembly
Remove lock bar
Pin Connector
Hook Window
Hook
Insert Lock Bar
Remove
Assembly
Pin Connector
25