Metabo HPT DH 3628DD Instrucciones De Seguridad Y Manual De Instrucciones página 18

English
Change lever
Grip
(3) Turn the change lever to
Then bull point or cold chisel is locked.
7. Using depth gauge (Fig. 26)
(1) Loosen the knob on the side handle, and insert the
depth gauge into the mounting hole on the side
handle.
(2) Adjust the depth gauge position according to the
depth of the hole and thighten the knob securely.
Depth gauge
Side handle
8. How to use the drill bit (taper shank) and the taper
shank adapter
(1) Mount the taper shank adapter to the rotary hammer
(Fig. 27).
(2) Mount the drill bit (taper shank) to the taper shank
adapter (Fig. 27).
(3) Turn the switch ON, and drill a hole in prescribed
depth.
18
Push button
Fig. 24
Fig. 25
mark (Fig. 23).
Mounting hole
Fig. 26
(4) To remove the drill bit (taper shank), insert the cotter
into the slot of the taper shank adapter and strike the
head of the cotter with a hammer supporting on the
rests (Fig. 28).
Drill bit
Taper shank adapter
Taper shank adapter
OPERATIONAL CAUTIONS
Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous work may cause the temperature of the
unit to rise, activating the temperature protection
circuit and automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous works, rest the unit for
15 minutes or so when replacing the battery. The
temperature of the motor, switch, etc., will rise if
the work is started again immediately after battery
replacement, eventually resulting in burnout.
Front cap Grip
Fig. 27
Cotter
Rest
Fig. 28