Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRIC SAFETY
An electric shock can be a source of a direct or indirect, or even fatal, serious accident.
Never touch the live parts of the torch as it is connected to the cutting circuit.
Do not touch the torch and the ground clamp at the same time.
Always use dry, well-maintained clothing to isolate yourself from the cutting circuit. Wear insulating shoes, no matter where you work.
PRECAUTION FOR USE
Never wrap the cutting leads around your body.
Do not use the cables or torch to move the machine.
The torch must be fully uncoiled to prevent overheating.
Switch off the generator after the torch is cooled and before each maintenance and before replacing or control wearing parts.
Regularly check the condition of the torch. If damaged, the torch must be replaced.
GENERAL DESCRIPTION
SPECIFICATIONS
The TPT torches are intended to the manual PLASMA cutting process.
SET UP
Designation
Reference
Length
Ignition voltage
Maximal rated current
Operating factor to 40°C
Gas type
Torch cooling mode
Room temperature range for cutting
Ambient temperature range for transport or storage
Applied standard
Electrode cross-section
Type of connector on the product side
Compatibility with cutting power generator
Inlet Pressure Range
INSTALLATION
TORCH CONNECTION REQUIREMENT
The generator must previsouly be powered off.
Insert the torch's connector (A) in the female compartment (E) and screw the B part. Be careful to tighten the torch.
To remove the torch, unscrew in the same manner as above.
TPT 40 & 25
Easycut 30FV, Easycut 40 and
Torch connector TPT40 (IPT)
8
7
6
Pins 1 and 2 : Switch
Pins 4 and 6 : Pilot arc
TPT 40
060753
4 m
500 V
40 A
60% (40 A)
air
air
-10 -> +40°C
-10 -> +55°C
EN 60974-7
4 mm²
IPT connector
Easycut K25 and Easycut 25
Plasma 45CT
2.5 > 6.5 bars
Torch connector TPT 25
(MINIFIT)
1
8
2
3
7
4
6
5
Pins 1 and 2 : Switch
Pins 4 and 6 : Pilot arc
EN
TPT 25
068087
700 V
25 A
35% (25 A)
2,5 mm²
Minifit
1
2
3
4
5
7
Publicidad
