Hitachi DH 24PF Manual De Instrucciones página 11

6. Mounting the drill bit (Fig. 2)
CAUTION:
To prevent accidents, make sure to
turn the switch off and disconnect the
plug from the receptacle.
NOTE:
When using tools such as bull points,
drill bits, etc., make sure to use the
genuine parts designated by our
company.
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner
into the tool holder until it latches
itself. (Fig. 2)
(3) Check the latching by pulling on the
drill bit.
(4) To remove the drill bit, fully pull the grip
in the direction of the arrow and pull
out the drill bit. (Fig. 3)
7. Installation of dust cup or dust
collector (B) (Optional accessories)
(Fig. 4, Fig. 5)
When using a rotary hammer for
upward drilling operations attach a
dust cup or dust collector (B) to collect
dust or particles for easy operation.
Installing the dust cup
Use the dust cup by attaching to the
drill bit as shown in Fig. 4.
When using a bit which has big
diameter, enlarge the center hole of the
dust cup with this rotary hammer.
Installing dust collector (B)
When using dust collector (B), insert
dust collector (B) from the tip of the
bit by aligning it to the groove on the
grip. (Fig. 5)
Front cap
Part of SDS-plus shank
Drill bit
Fig. 2
Grip
Fig. 3
Dust Cup
Fig. 4
Dust Collector (B)
Fig. 5
English
Grip
11