CASO DESIGN HW 550 Manual De Instrucciones página 29

13.2 Control panel
"Lo" is displayed: Add water.
Temp-button: Set the desired
temperature according to 000 (water
temperature without heating), 40°C,
50°C, 60°C, 70°C, 80°C, 90°C, 100°C.
Volume-button: Set the water volume
according to 100ml, 150ml, 200ml,
250ml, 300ml, 350ml, 400ml, 000 (continuous water flow)
Lock-button: Press the button for about 3-5 seconds to unlock the device.
After approximately 30 seconds without operation it locks automatically. Press the
button again to unlock the device.
Start/Stop-button: Start and stop the dispense of water.
13.3 Rating plate
The rating plate with the connection and performance data can be found beneath the device.
14 Operation and Handling
This chapter provides you with important notices with regard to operating the device. Observe
the following notices to avoid dangers and damages.
Warning
► Do not leave the device unsupervised during operation.
14.1 Before initial use: Preparation of the device
1. Place device without drip tray.
2. Fill the tank up to max marking.
3. Place vessel below the spout which can collect whole content of watertank.
4. Start the device with 000 temperature setting until ca. 300 ml water is dispensed.
5. Turn to 100°C temperature setting with continuous water flow and let the device dispense
water.
6. When device shows Lo (watertank is empty), then the process is finished.
7. The device can now be filled with fresh water.
8. The device is ready for use.
29