Publicidad
Idiomas disponibles
Idiomas disponibles
Safety guidelines for battery
chargers
This tool may be used by children
■
aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities
or lack of experience and knowl-
edge, provided that they are
under supervision or have been
told how to use the tool safely
and are aware of the potential
risks. Do not allow children to
use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their
customer service department or
a similarly qualified person.
The charger is suitable for indoor use
only.
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
ATTENTION!
♦
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
♦
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
PDSSAP 20-Li B3
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry, and the ambient
temperature should be between 0°C and
50°C.
♦
Insert the battery pack 8 into the high-speed
charger 0 (see fig. A).
♦
Insert the power plug into the socket. The green
charge control LED r lights up briefly, then the
red charge control LED e lights up.
♦
The green control LED r indicates that
charging is complete and the battery pack 8
is ready for use.
ATTENTION!
♦
If the red control LED e flashes, this means
that the battery pack 8 has overheated and
cannot be charged.
If the red and green control LEDs e r both
♦
flash, this means that the battery pack 8 is
defective.
♦
Push the battery pack 8 into the tool.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains power
socket.
7
GB │ IE
│
■
Publicidad
