Pfannenberg DTT 6401 Serie Instrucciones De Servicio página 75

GB
Assembly with quick-release frame
Unit preparation - unit cover removal
1
2
Figure 23 – Loosening the unit cover
Pos Designation
1 Right cover screws (2x)
3 Ground cable
Procedure
 Unscrew the two screws on the right side of the unit (1) and the two screws on the left side of the unit (2).
 Disconnect the ground cable (3); see the figure Loosening the unit cover.
 Remove the four screws on the top side of the unit (4).
 Carefully pull the unit cover (5) upwards; see the figure Unit cover removal.

The cover has been removed from the cooling unit.
Unit preparation – Bracket assembly
Figure 25 – Bracket assembly
Procedure
 Make a hole in the insulation of the bracket opening (6) with a screwdriver. Make 2x on the right and 2x on the
left.
 Mount the two brackets (7) with the four screws (7) and the four washers (accessory kit). The openings of the
brackets face forwards; see the figure Bracket assembly.
 Install the cover and front panel in the reverse order.
 Tighten the screws, connect the ground cables; see the figure – Cover installation.

Unit preparation is completed. The cooling unit is ready for installation with the quick-release frame.
Operating Manual DTT 6401 Multicontroller (MC) 086100035a © Pfannenberg GmbH
3
6
7
5
Figure 24 - Unit cover removal
Pos Designation
2 Left cover screws (2x)
4 Top cover screws (4x)
Figure 26 – Cover installation
4
Page 25 / 50