Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
To keep your wet/dry vac looking its best, clean the outside with a
cloth dampened with warm water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild soap.
3. Wipe out with dry cloth.
STORAGE
Before storing your vac, the dust tank should be emptied and
cleaned. The cord should be wrapped and hung on the unit and the
accessories should be kept in the accessory holder so they can be
readily available. The vac should be stored indoors.
TROUBLESHOOTING
WARNING!
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
AND/OR ELECTRICAL SHOCK, TURN POWER SWITCH OFF
AND DISCONNECT GROUNDED PLUG FROM ELECTRICAL
OUTLET BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be fixed without calling customer service.
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Ensure the on/off switch is in the ON
position ( )
Remove blockages in the suction nozzle,
suction tube, suction hose or filters.
Replace the paper or fleece bag.
Suction capacity
Check for proper installation of the filters.
decreases
Clean or replace the filters.
Empty canister, refer to Emptythe tank
under Operating .
Thermal overload has been tripped:
Vacuum stops running
Check for proper installation of the filters.
Ensure filters are not damaged; replace if
Dust comes out while
necessary.
vacuuming
Ens
secure.
11
SOLUTION
1. Turn the vacuum off and disconnect
vacuum cleaner from power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an appropriate
outlet and turn on/off switch to the ON
position ( ) to test. If vacuum will not
restart call 1-888-899-0146
.
ure filter seals are in place and are
Publicidad
