Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the battery
Install a 12V MN21/A23 battery (included) into the
wall control. To prevent damage to the remote
control, remove the battery if not used for long
periods. (Fig. 15)
3 4
2
0
Figure 15
1
6
Battery
Wall Control Button Definitions: (Fig. 16)
These six buttons are used to set the fan speed as
follows:
1 = minimum speed
2 = low speed
3 = medium low speed
4 = medium speed
5 = medium high speed
6 = high speed
0 = turns the fan off.
button: Controls fan direction.
button: Controls light. Switch the "D" and "ON" dip
switch on the back of transmitter to decide the light in
"ON/OFF" or "Dimmable" condition.
5
ON - OFF Slide button: This button turns the power
on and off to the fan and light.
Your DC brushless motor is equipped with an
automatically learned type remote control. There are
no frequency switches on the receiver; the receiver
unit will automatically scan the frequency from the
wall control if any changes are made. The frequency
settings on the transmitter should be changed ONLY
in case of interference or if a second or more
ceiling fans with the same type of control system
are installed in the same structure.
Operating Your Transmitter 12.
Setting the Remote Control
Follow the below steps to set the wall control: The auto
learning function will only mandate within 60 seconds
when turning the fan's AC power ON.
a) Select desired frequency from the transmitter. The
dip switches can be set to 16 different combinations.
(Fig. 17)
b) From the front of the transmitter, with the
fan's power off, restore power to the fan. Press
and hold "SET" button for about 5 seconds and
release. The signal light on the wall transmitter
will come on when the button is pressed. The
fan has completed the pairing process with the
wall control and is ready for use. (Fig. 17)
NOTE: If the self calibration test failed, turn the AC
power off; restore power and process the self
calibration test again.
NOTE: During self calibration test, the remote is
non-fuctional.
NOTE: The learning frequency function and self
calibration test will continue to retain the last set
frequency and calibration set even when the AC
power is shut off. If the frequency is changed the self
calibration test will occur again.
Publicidad
