Publicidad
Idiomas disponibles
Idiomas disponibles
Stand fan
Base and stand assembly:
1. Take out the base and stand parts from the box.
2. Turn the height adjustor counterclockwise, and draw the steel tube out of the stand. Then turn the height
adjustor clockwise to secure it.
3. Insert the stand into the base, fit the screw nut to the stand from the bottom of the base and fasten it.
4. Adjust the height to meet you requirements for the fan's height.
Fan head and column assembly:
1.
Unscrew the knob on the bottom of the fan body.
2.
Put the extension column into the hole of the fan body, then tighten the knob to secure it.
3. Remove the spinner and the plastic nut from the front side of the motor shaft and then tighten the plastic
nut. (Figure 1)
FIGURE 1
4.
Insert the blade into the shaft, making sure the stopper pin is clipped into the groove of the blade. Screw
the spinner counterclockwise to tighten the blade. (Figure 2)
FIGURE 2
5. Put the front grill onto the rear grill and close the clips to tighten both the front and rear grills together.
Operating instructions
Speed function:
Use the "speed" switch to turn the fan "on/off" and adjust the speed by pressing the switch tone of the
following numbers:
0-Off
2-Medium
1-Low
3-High
Rotate function:
To start the fan rotating, press the rotate knob located at the top of the motor casing.
To get the directional airflow, pull the rotate knob.
Angle function:
Unscrew the angle knob, adjust the fan head to the desirable angle by holding the fan head, then tighten the
knob.
Maintenance:
•
To keep the fan clean, wipe it with a soft cloth with a mild detergent. Be careful not to use abrasives to
clean the plastic parts of the fan.
•
To ensure that the fan keeps functioning properly, apply drops of clean motor oil to the front and back
bearings of the motor every 12 months.
•
Before storage, clean the fan completely, then put the plastic bag over the fan and store in a cool dry
place.
ENGLISH
1. Lock
2. Spinner
3. Grill Lock
4. Nut
5. Plastic
1. Spinner
2. Lock
3. Blades
4. Groove
5. Stopper pin
2
Publicidad
