Publicidad
Regulatory Information
file:///D|/cd/190WV7/190WV7CS.00%20EDFU-V1_061219/lcd/manual/ESPANOL/190WV7/SAFETY/REGS/REGULAT.HTM (3 of 10)2006-12-20 15:13:11
This monitor is equipped with a function for saving energy which supports the VESA Display
Power Management Signaling (DPMS) standard. This means that the monitor must be
connected to a computer which supports VESA DPMS. Time settings are adjusted from the
system unit by software.
VESA State
Normal operation
ON (Active)
Power Saving
Alternative 2
OFF (Sleep)
One step
Switch Off
®
A
E
S
s an
NERGY
TAR
®
the
E
NERGY
S
TAR
guidelines for energy efficiency.
We recommend you switch off the monitor when it is not in use for a long time.
RETURN TO TOP OF THE PAGE
Federal Communications Commission (FCC) Notice (U.S. Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Use only RF shielded cable with ferrite core that supplied with the monitor when connecting this monitor to a computer
device .
If your RF shield cable without ferrite core, we recommend to contact with Philips Customer & Service center for more
information.
LED Indicator
Power Consumption
Green
< 36 W (typ.)
Amber
< 1 W
Off
< 1 W
P
PHILIPS
artner,
has determined that this product meets
Publicidad
