Publicidad
Idiomas disponibles
Idiomas disponibles
34
INSTALLATION INSTRUCTIONS
Installation Test (Duct check)
Once you have completed the installation of the dryer,
use this test to make sure the condition of the exhaust
system is adequate for proper operation of the dryer.
This test should be performed to alert you to any serious
problems in the exhaust system of your home.
• Your dryer features Flow Sense™, an innovative sensing
system that automatically detects blockages and
restrictions in dryer ductwork. Keeping ductwork clean
of lint buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
F
NOTE
The dryer should be cool before starting this test. If
the dryer was warmed up during installation, run the
AIR DRY cycle for a few minutes to reduce the interior
temperature.
To activate the installation test:
1. Remove the literature, and then close the door.
Do not load anything in the drum for this test, as in
may affect the accuracy of the results.
G
2. Press and hold the Temp. Control and Signal
buttons and then press the Power button.
This button sequence activates the installation test.
The code
successful.
3. Press Start/Pause button.
The dryer will start the test, which will last about
two minutes. The heat will be turned on and the
temperatures in the drum will be measured.
A
D
will display if the activation is
4. Check the display for results.
During the two minute test cycle, monitor the FLOW
SENSE™ display on the control panel. If no bars
are displayed, when the cycle ends, the exhaust
system is adequate. If the exhaust system is severely
restricted, the display will show four bars.
Other problems may also be shown with error codes.
Refer to the next page for error code details and
solutions.
B
5. End of cycle.
At the end of the test cycle,
C
The test cycle will end and the dryer will shut off
automatically after a short delay.
E
G
will display.
Publicidad
