Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
3.2. Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the distance
for the air circulation between the
product and the rear wall.
1. To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in
the figure.
3.3. Adjusting the feet
If the product stands unbalanced after
installation, adjust the feet on the front
by rotating them to the right or left.
3.4. Electrical connection
WARNING: Do not make
A
connections via extension
cables or multi-plugs.
WARNING: Damaged
power cable must be
B
replaced by the Authorized
Service Agent.
If two coolers are to be
installed side by side, there
C
should be at least 4 cm
distance between them.
Our company shall not be liable
for any damages that will arise
when the product is used without
grounding and electrical connection
in accordance with the national
regulations.
Power cable plug must be within easy
reach after installation.
Do not extension cords or cordless
multiple outlets between your
product and the wall outlet.
3.5. Changing the
illumination lamp
To change the Bulb/LED used for
illumination of your refrigerator, call your
Authorized Service.
The lamp(s) used in this appliance is not
suitable for household room illumination.
The intended purpose of this lamp is to
assist the user to place foodstuffs in
the refrigerator/freezer in a safe and
comfortable way.
3.6. Door Open Warning
(This feature is optional)
An audio warning signal will be given
when the door of your product is left
open for at least 1 minute. This warning
will be muted when the door is closed
or any of the display buttons (if any) are
pressed.
10 / 22 EN
Refrigerator/User Manual
Publicidad
