Sulion MAKI Manual página 11

Remote control
2H
3
4
FAN
2
5
OFF
6
1
Syncing the receiver and the remote control for fan operation
If the receiver and transmitter of this fan are properly synchronized, the fan will work. During synchronization the receiver
recognizes the signal from the transmitter, this is called the learning process.
Make sure the fan is disconnected. This is essential for the synchronization process.
Unless the synchronization process has been successful, the fan will work partially or will not work. By default, all fans have
been preconfigured at the factory and should be functional once the installation is completed and the fan is turned on.
If the remote control does not work after installation or during use, synchronization can be performed as indicated below. Note
in any case that there could be other reasons why your fan or remote control does not work:
Make sure all connections are correctly made.
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
Instructions for synchronizing the receiver and the remote control
The control of this fan does not require synchronization with the recelver, the control is already factory-linked with its receiver;
Universal mode and Unit mode:
- Unit Mode:
This type of synchronization allows you to control two or more nearby fans independently, each with its remote control.
Synchronization:
The control of this fan does not require synchronization with the receiver, the control is already factory-linked with its receiver
- Universal Mode:
This type of synchronization allows you to control one or more nearby fans with the same remote control.
Synchronization:
1.- On and Off the Switch for 8 times. Then you will heard "beep beep beep".
2.- Within 2 seconds press
It is not possible for a controller to forget a fan once it has been linked, if you want a fan to leave
to obey a command, another one must be linked to "overwrite it".
Remote control safety functions
Blocking protection
The remote receiver includes a function that automatically blocks motor operation, cutting current to the motor 30 seconds
after detecting an obstruction in front of the fan that prevents normal operation. When this happens, you must remove the
obstacles blocking the fan. Then, press the off button on the remote control to reset the receiver. Now you can continue to
use the fan normally.
Note: Unless you remove the obstruction blocking the fan, it will not operate correctly.
FAN
Turn on / Turn off
OFF
Turn on / turn off light /
Change color temperature of the light.
Natural wind (Speed cycle 1-6
progressive)
Self-temperature sensor
26ºC Speed= 6
26ºC - 19ºC Speed= 3
<19ºC Speed=1
Note: Press another button except
to exit the function.
Timer 2h
2H
Change sense of rotation
1
Speed 1
2 Speed 2
3 Speed 3
Speed 4
4
Speed 5
5
Speed 6
6
for 1-2 seconds. Then will heard "beep beep", setting completed.
FAN , 2h or
OFF
11