Sanus DECORA DLL1 Manual De Instrucciones página 9

3. Drill pilot holes using a 7/32 in. (5 mm) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the studs.
IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4. Install wall plate assembly
wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
14
15 16
using four lag bolts and four washers
3 in.
(75 mm)
7/32 in.
(5 mm)
14
.
17
. Tighten the lag bolts only until they are pulled firmly against the
4
15
17
17
16
9