Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting the camera
Observe the following installation instructions:
• To provide a suitable viewing angle, the camera must be attached at a height of
at least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
• Make sure that the installation location of the camera is sufficiently firm (e.g. to
prevent the camera from being knocked down by branches that may brush the
roof of the vehicle).
• Mount the camera horizontally and in the middle of the rear of the vehicle
(fig. d, page 6).
• The most secure type of attachment is with screws fitted through the body.
Please observe the following instructions:
– There must be sufficient space behind the chosen installation location to be
able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any
holes made (e.g. by using screws and sealant and/or spraying the outer
attachment parts with sealant).
– The location on the body where you wish to attach the camera must be rigid
enough to allow the camera to be tightly fastened.
• Check beforehand that there is sufficient space on the other side for the drill head
to come out (fig. 2, page 3).
• If you are not sure about the location you have chosen, ask your vehicle
manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera holder at the chosen location and mark at least two different
points for the drill holes (fig. e, page 6).
➤ Using a hammer and centre punch, gently pre-punch the previously marked
points to prevent the drill head from slipping off.
18
PerfectView CAM604
EN
Publicidad
