EarthWise LST05815 Manual Del Operador página 5

INSTALLING STRING TRIMMER ATTACHMENT TO POWER HEAD
The attachment connects to the power head by means of a
coupler device.
●
Remove the battery pack.
●
Loosen the wingnut on the coupler of the power head shaft.
●
Pull the retaining pin located on the power head shaft and rotate
1/4 turn. Rotating allows the pin to lock out of the shaft even when
released.
●
Align the hole in the attachment shaft with the retaining pin on the
power head shaft and slide the two shafts together.
●
Rotate the retaining pin 1/4 turn to allow
the pin to fully seat through the hole in
the attachment shaft.
NOTE: If the pin does not release
completely in the positioning hole, the
shafts are not locked into place. Slightly
rotate from side to side until the pin is
locked into place.
●
Tighten the wingnut securely.
WARNING: Be certain the wingnut is fully tightened before operating
equipment; check it periodically for tightness during use to avoid
serious personal injury.
Removing the Attachment From the Power Head
●
Stop the motor and remove the battery pack.
●
Loosen the wingnut.
●
Pull the retaining pin and twist the shafts to remove and separate
ends.
TO TURN THE TOOL ON
Select the desired operating speed (Hi or Low). Press and hold the
trigger lock out button at the top of the front handle and squeeze the
switch trigger with your fingers.
TO TURN THE TOOL OFF
Release the switch trigger.
Before you start the unit, make sure the trimmer is not contacting any
object.
WARNING: Stones, pieces of metal and other objects can be thrown out
at high speed by the line. The unit and guard are designed to reduce the
danger.
WARNING: To guard against injury, observe the following:
Read instruction manual before using, save instruction manual.
Keep hands away from lines.
Keep hands on handles. Don't overreach.
ASSEMBLY
INSTALLING/REMOVING BATTERY PACK
To install battery pack:
Align grooves on battery pack with raised ribs in the tool's
●
battery port and place the battery pack in the tool.
Warning: Make sure the latch on the tool snaps in place and the
battery pack is fully seated and secure in the battery port before
beginning operation. Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in serious personal injury.
To remove battery pack:
●
Press the battery latch button on the tool and pull the battery
pack out of the battery port.
Warning: To avoid serious personal injury, always remove the
battery pack and keep hands clear of the trigger lock-out when
carrying or transporting the tool.
OPERATING
If you strike or become entangled with a foreign object, stop tool
immediately, check for damage and have any damage repaired before
further operation is attempted. Do not operate with a broken hub or
spool.
Low Speed
5
Battery release button
High Speed
Two Speed Button