Using The Water Dispenser; Features And Parts List; Loading The Dispenser And Start Up; Child Safeguard - GE Profile GXCF35GBS Manual Del Propietário

Using the water dispenser.

Child
safeguard
4

Loading the Dispenser and Start Up

IMPORTANT: Make sure the dispenser is unplugged.
Before placing the water bottle on the dispenser, wash
hands and wipe the top of the bottle with a clean cloth.
Avoid touching the part of the bottle that will be in
contact with the water dispenser.
Make sure the water level in the top of the dispenser
is low enough to allow for proper bottle installation.
Failure to do so may cause the dispenser to overflow.
Sanitize the dispenser water tanks prior to installing
a full bottle of water for the first time (see "Sanitizing
and Cleaning the Water Tanks").
1. Peel the label from the top cover of the bottle.
Do not remove the entire bottle cap or press in
the center plug.
2. Place the bottle on top of the dispenser as
shown, aligning the center plug with the probe.
Press down until the probe pushes the center

Child Safeguard

The HOT dispenser button is equipped with
a child safeguard that reduces the risk of hot
water being dispensed accidentally or by small
children. To dispense water, rotate the knob
counterclockwise and push the button in.
The knob will reset automatically when the
button is released.

Features and Parts List

Bottle Support Collar—Black (WS28X10035)
Separator (WS28X10013)
Cold Water Tank
Control Panel
Hot , Room Temperature
Dispenser Drip Tray (WS28X10031) and Grille (WS28X10032)
Compartment Drip Tray (WS29X10029)
Chiller Compartment. The compartment is intended solely for
use in chilling canned and boxed beverages and packaged
nonperishables.
Compartment Shelf (WS28X10028)
Drainage Cap (WS01X10008)
Silicon Stopper (WS01X10007)
plug out of the cap and into the water bottle,
allowing the bottle to rest on the support collar.
The plug may remain on top of the probe or
may be released to float in the water; both
conditions are normal.
3. IMPORTANT: Press the hot and cold dispenser
buttons until water runs from both taps.
4. Plug in the dispenser.
5. Set the clock, hot water temperature level and
energy saver cycle. See the Start Up and Operation
Adjustment section for detailed instructions.
6. Press the
7. Allow 30 minutes for water to reach hot and
cold temperatures.
Contact a local water bottle distributor to purchase
water bottles.
The dispenser heats water up to a temperature of
195°F (91°C). Water temperatures above 125°F (52°C)
can cause severe burns or death from scalding.
Children, the disabled and the elderly are at highest
risk of being scalded.
CAUTION:
a parent when using this product.
, Cold Water Dispenser Buttons
(power) button.
Children should be supervised by