Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the operating temperature
Your unit has only one control for regulating the temperature in the
compartment. The temperature control is located on the upper right-hand
side of the compartment. The first time you turn the unit on, set the
temperature control to "5".
The range of the temperature control is from position "0" to "5". After 24
to 48 hours, adjust the temperature control to the setting that best suits
your needs. The setting of "3" should be appropriate for home or office
use.
To turn the appliance off, turn the temperature control to "0".
NOTES: Turning the temperature control to "0" position stops the cooling cycle but does not
shut off the power to the unit. If the unit is unplugged, has lost power, or is turned off, you
must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time
delay, the unit will not start.
If the refrigerator is not used for a long period of time, proceed as follows:
-
Disconnect the refrigerator from the main supply by removing the plug from the wall
socket.
-
Clean and dry the inside as instructed under the heading of "Maintenance and Cleaning".
-
Leave the door open to prevent any unpleasant smells from building up while the
refrigerator is not in use.
Important: Changes in weather conditions (temperature and humidity) and
the frequency with which the doors of the two separate compartments are
opened may affect the refrigerator's operating temperatures.
Maintenance and Cleaning
Defrosting
1. When the refrigerator working for a period of time, the inner surface of the refrigerator
will be covered with a layer of white frost. It may raise the electricity consumption and
lessen the effect of refrigeration. Then you should remove the frost at once.
2. When defrosting, turn the knob to "0" position cut off the power, open the door and move
frozen/cooling foods to a shady and cooling place, defrost with a plastic scraper, or let the
temperature rise naturally till frost melts. Then wipe away remaining ice and water, and
switch on electricity again.
Notes: Never use sharp metal tools or it will damage the refrigerator.
Warning: the amount of ice which forms on the back wall may vary with
changes in weather conditions (temperature and humidity), the frequency
with which the door is opened, the appliance's operating temperatures and
the amount of fresh foods stored inside (especially fruit and vegetables).
7
English
Publicidad
