Publicidad
Idiomas disponibles
Idiomas disponibles
28
C
onnecting Water Supply Hose
Normal Type
1
Separate Middle connector from Water Supply Hose
Separate Middle connector from the Water
Supply Hose by pulling the Pressing Rod and the
Pressing Handle that is attached to the Water
Supply Hose.
2
Loosen the fixed nuts to connect the connector to the tap
Untighten the screw of the connector so that the
tap can be placed in the middle.
NOTE
In case tap is too large.
If the tap diameter is too large or is square,
untighten the 4 screws and remove the guide
plate. Then follow step1.
3
Fixing Connectors to the Tap
Push the upper connector up till the rubber
packing is in tight contact with the tap. Then
tighten the 4 screws.
4
Fixing Upper Connector and Middle Connector
Remove the fixed sticker in between the Upper
and Middle Connectors. Tighten the connectors
by holding one connector and twist middle
connector to the right.
5
Connecting Middle Connector and Water Supply Hose
Press down the pressing rod of the Water Supply
Hose which was separated from middle connector
(refer to Step1) and then join it to the middle
connector.
6
Check for water leakage
After connecting the hose, open the tap to check
for any water leakage.
If the connection leaks, close the tap and start
again from step 1.
If you skip step 1, water leakage may occur.
(Normal tap without thread & one touch type inlet hose.)
Middle
connector
Guide plate
Connector
Connector
Middle
Connector
Fixed sticker
Pressing rod
Water Supply Hose
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Rubber packing
screw
Fixed sticker
Rubber packing
Connector
Middle
Connector
Pressing handle
Publicidad
