Efco DS 2800 Manual De Instrucciones página 14

en
22
14
ASSEMBLY
WARNING: Only use cutting attachments with the
guards we recommend! See the chapter on
Recommended cutting attachments (Page 10). Refer
to the instructions for the cutting attachment to
check the correct way to load the cord and the
correct cord diameter. Keep the teeth of the blade
correctly sharpened! Follow our recommendations.
Also refer to the instructions on the blade packaging.
Maintain the correct blade setting! Follow our
instructions.
21
WARNING: Always stop the engine before doing any
work on the cutting attachment. The attachment
continues to rotate even after the throttle has been
released. Ensure that the cutting attachment has
stopped completely and disconnect the HT lead from
the spark plug before you start to work on it.
WARNING: Using an incorrect cutting attachment or
an incorrectly sharpened blade increases the risk of
kickout.
WARNING: Always discard a blade that is bent,
twisted, cracked, broken or damaged in any other
way (Fig.20). Never attempt to straighten a twisted
blade so that it can be reused. Only use
blades of the specified type.
WARNING: To reduce the risk of serious injury, never
use wire or metal-reinforced line or other material in
place of the nylon cutting lines. Pieces of wire could
break off and be thrown at high speed toward the
operator or bystanders.
Fitting the trimmer head (Fig.21)
Put the upper (F) flange in place. Put the head fixing pin (L) in the
appropriate hole and tighten the head (N) anti-clockwise by hand.
FITTING THE BLADE (excluding machines with bent drive
shaft-TR) (Fig. 22)
Loosen the bolt (A) clockwise; remove cup (D) and lower flange
23
(E).
Fix the blade (R) onto the upper flange (F) making sure that the
rotation direction is correct.
Fix the lower flange (E), the cup (D), and tighten bolt (A) anti-
clockwise.
Put the pin provided in the appropriate hole (L) to block the blade
and allow the bolt (A) to be tightened to 18 ft lb (25 Nm).
WARNING: Arrows on the cutting attachment guard
(Fig.23) show the correct direction of rotation of the
cutting tool.
WARNING! This machine is not suitable for use with
disc for wood (22-60-80 teeth) and relevant metal
guard.
24
WARNING! – On machines with a bent drive shaft
(TR) it is not possible to fit disks, only line heads.
WARNING: Fit the blade protection (M) p.n. 4196086
as shown (Fig.24) before transporting or storing the
brush cutter.
CAUTION: Never use the brush cutter without the
cup (D, Fig.22) to avoid damages to the thread.
original