Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING/DISASSEMBLING CHILD RESTRAINT
Adult assembly: 2 x Phillips Screwdrivers required.
1. Locate both sets of screws with plastic knob, washers
and plastic encased inner bolts (Part T) in the
hardware bag and set aside.
2. Locate the 0.5 inch (1.3 cm) screw and washer (Part X)
in the hardware bag and set aside.
3. Identify the 8.8 inch (22.3 cm) backrest connector rod
(Part W) pre-installed in base of backrest. Remove
and set aside.
4. Connect the backrest to the base in the upright
position, ensuring that the backrest inserts snugly
around the outside of the armrest grooves.
TIP: Stretch
out slightly to help guide them
around the armrest grooves.
5. Insert screw, washers (x2) and inner
bolt as indicated in each armrest
❶. Ensure that the bolt is properly
aligned with the indentation ❷ .
Secure assembly by turning screw
clockwise until tight ❸.
TIP: If screws do not pass through
easily, make sure that the screw
holes are aligned and tap screw
head lightly to guide it through
the armrest plastic.
6. Turn the child restraint over and
slide the base plate between
the two backrest anchor points.
21
backrest
extensions
❶
❷
❸
Publicidad
