Publicidad
Idiomas disponibles
Idiomas disponibles
•
To remove the battery pack, push and hold the
battery release button. Then pull out the battery
pack.
To start the motor
1. Install the battery pack. See
pack on page 9 .
2. Push the power button until the light is on.
3. Squeeze the trigger to operate.
•
Squeeze the trigger lightly for lower speed.
•
Squeeze the trigger more for higher speed.
4. Use the product.
10
To install the battery
To stop the motor
1. Release the trigger.
2. Push the power button until the light is off.
To change the power mode
The power mode of the product can be changed while
the product is in operation. There are 2 power modes:
1. Standard mode - Saves energy and maximizes run
time. Standard mode is applicable for most tasks.
Note: The product is set to Standard mode when
started.
2. Boost mode - The product operates at high speed in
Boost mode. Boost mode runs at maximum power
for tasks that are not easy. To start Boost mode,
push the Boost mode button until the light is on. To
stop Boost mode, push the Boost mode button until
the light is off.
Note: If the trigger is released during operation, the
product starts in the last mode. If the product
automatically stops, or if the operator pushes the power
button, the last used mode is erased from memory. The
product is set to Standard mode again when started.
To start the digital cruise control
The digital cruise control lets you set and hold a blower
speed without the trigger.
1. Hold the trigger at the necessary position and
engage the digital cruise control.
2. Release the trigger after the digital cruise control is
engaged.
Note: While the digital cruise control is
engaged, the trigger can be pulled again
to increase speed. After releasing the
trigger, the digital cruise control goes
back to its last position.
3. Disengage the digital cruise control to continue usual
operation of the product.
314 - 002 - 17.11.2017
Publicidad
