Publicidad
Idiomas disponibles
Idiomas disponibles
3. DESCRIPTION
1
2
3
4
5
6
4. INSTALLATION INSTRUCTIONS
Before using your thermoelectric cooler
Remove the inner and outer packaging.
Allow the appliance to rest for two hours before switching it on.
Clean the inside using a soft cloth and lukewarm water.
Installing your appliance
This device is only intended to be installed in free standing, in no case it must be installed in
a built-in or embeddable way. For a good functionality of the device it is imperative to leave
a good air circulation all around the device. We do not take responsibility for failure to
comply with the installation instructions.
Position it in a place with sufficient strength to support its weight when loaded. To ensure
that it is level, adjust the height of the feet underneath.
To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and
do not place it in a room which is too cold.
Connect the appliance to a single socket, leaving a 10 cm gap between the back of it and the
wall and 2 cm on each side. Be careful to support it, so that it is perfectly level. (Use of a
spirit level is recommended). This will prevent any movement due to instability, causing
noise and vibration, and will ensure that the door seals perfectly.
7
1
2
8
3
4
9
5
10
6
11
7
8
9
10
11
12
12
16
Cabinet
Shelf
Cold fan
Cold fan cover
Ventilation holes
Leveling feet
Upper hinge cover
Glass door
Door gasket
Door partition
Double zone partition
Bottom hinge
Publicidad
