Publicidad
Idiomas disponibles
Idiomas disponibles
24" & 30" PEDESTAL FANS: 24P / 24POSC / 30P / 30POSC
Installation and Assembly
Tools Needed:
Pliers
Phillips head screwdriver
Flat head screwdriver
Adjustable wrench
Parts Included In Box:
(1) Base
(1) Front Guard
(1) Rear Guard
(1) Motor Assembly
(1) Fan Blade Assembly
(1) Locking Collar
(1) Upper Support Pole
(1) Lower Support Pole
(1) Support Pole Spring
Bag of hardware
Nut
Figure 1: Attaching Motor to Motor Support Assembly
Figure 2: Attaching Rear Guard to Motor
© 2019, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE
Motor Assembly
Pivot Bolt
Upper Support Pole
Rear Guard
Motor
3
1. Remove the base from rear guard. Keep the (2)
screws holding the base to the rear guard. These
screws will be used to connect the base and lower
support pole.
2. Place the fan base on level ground.
3. Loosen the locking collar on the support pole using the
provided Allen wrench (hex wrench). Extract the upper
support pole slowly to adjust the height of the fan. The
support pole must be fully extended before the spring
is placed inside. Place the spring into the bottom of the
upper support pole. Note: the pole spring is covered
in oil to prevent it from rusting. Be careful not to let
it come into contact with clothing or bare skin.
4. Place the support pole plug into the bottom of the
upper support pole to secure spring in the upper sup-
port pole.
5. Mount entire support pole to the base. Align holes
and use (3) screws from the hardware bag and the (2)
screws from Step 1 to secure the entire support pole
to the base.
6. Push down the base cover over the base support
bolts.
7. Mount the motor assembly to the connector on the
upper support pole (see Figure 1). Make sure the
holes align.
8. Secure motor assembly with Pivot Bolt and Nut.
Tighten the nut and bolt firmly using the wrench.
9. Slide the rear guard onto the motor assembly and
secure it with (4) flange screws (screws from the
motor). See Figure 2. Tighten the screws firmly using
the wrench.
10. Loosen the screw on the back of the fan blade assem-
bly using the Allen wrench (Hex Wrench). Slide the fan
blade assembly onto the motor shaft.
11. Tighten the screw on the back of the fan blade assem-
bly using the Allen wrench onto the flat part of the fan
shaft.
12. Attach the front guard to the rear guard and secure
with the fasteners on the front guard.
NOTE: This model CAN NOT be wall mounted
CAUTION
the shaft! This will cause the fan blade to spin
improperly, damaging the fan! Be sure that fan
shaft is flush with front of fan blade assembly.
High Velocity Fan User's Manual
Do NOT slide fan
blade screw beyond
the groove on
Publicidad
