Operation; Switching On/Off; Behavior In The Event Of A Fault; Transport - Bosch BBS266 Instrucciones De Servicio

English – 14
Start-up
Use only original Bosch batteries that the manu-
u
facturer has approved for your eBike. Using
other batteries can lead to injuries and pose a fire
hazard. Bosch accepts no liability or warranty
claims if other batteries are used.

Switching on/off

Switching on the battery is one way to switch on the
eBike system. Read and follow the instructions in the
operating manuals for the drive unit and on-board
computer.
Before switching on the battery, i.e. the eBike sys-
tem, make sure that the lock (6) is closed.
To switch on the battery, press the on/off button (4).
Do not use sharp or pointed objects to press the but-
ton. The LEDs on the indicator (3) will light up, indi-
cating the battery's state of charge at the same time.
Always check that the battery pack is locked in
u
place. To do this, pull on the battery pack (after the
key has been removed).
Note: If the battery capacity is less than 5 %, none of
the LEDs on the battery charge indicator (3) will light
up. The only way to see if the eBike system is
switched on is via the on-board computer.
To switch off the battery, press the on/off button (4)
again. The LEDs on the indicator (3) go out. This will
also switch the eBike system off.
Always remove the battery pack from the bicy-
u
cle before transporting the bicycle on a vehicle
bike rack. Failure to remove the battery pack when
using a vehicle bike rack can lead to death or seri-
ous injury. The battery may detach during transport
and cause an accident to following vehicles.
Always use an approved and compatible bicycle
u
rack when transporting your eBike. The Bosch
drive system adds weight to the bicycle. Refer to
0 275 U07 XPX | (09.04.2020)

Operation

If no power is drawn from the eBike drive for about
10 minutes (e.g. because the eBike is not moving)
and no button is pressed on the on-board computer
or the operating unit of the eBike, the eBike system,
and therefore also the battery, will switch off auto-
matically to save energy.
The battery is protected against deep discharge,
overloading, overheating and short-circuiting by the
"Electronic Cell Protection (ECP)". In the event of
danger, a protective circuit switches the battery off
automatically.

Behavior in the event of a fault

The Bosch eBike battery must not be opened, even
for repairs. There is a risk that the Bosch eBike bat-
tery could catch fire, e.g. due to a short circuit. This
risk arises if a Bosch eBike battery which has already
been opened is reused at a later point in time.
Therefore, do not repair the Bosch eBike battery in
the event of a fault, but have it replaced with an origi-
nal Bosch eBike battery by your specialist retailer.

Transport

your bicycle rack manual to be sure your eBike is
compatible. Overloading a bike rack can result in
death or serious injury.
Use proper lifting techniques as electric bikes
u
are generally heavier than bicycles.
Ship batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the bat-
tery in such a manner that it cannot move around in
the packaging. Inform your parcel service that the
If a fault is detected in the
battery, two of the LEDs
on the battery charge in-
dicator (3) will flash. Con-
tact an authorized bicycle
dealer if this happens.
Bosch eBike Systems