LG WT4801CW Manual Del Propietário página 15

Connecting the drain line
Secure the drain hose in place to prevent moving and leaking.
NOTE
The drain hose should be properly secured. Failure to
y
properly secure the drain hose can result in flooding
and malfunction.
Total height of the house end should not exceed 96
y
inches (244.8 cm) from the bottom of the washer.
The drain must be installed in accordance with any
y
applicable local codes and regulations.
Make sure that the water lines are not stretched,
y
pinched, crushed, or kinked.
Using a standpipe
1
Insert the end of the drain hose into the standpipe.
Drain Hose
2
Use a tie strap to secure the drain hose in place.
39"
(99 cm)
Cable Tie
39"
(99 cm)
Cable Tie
INSTALLATION INSTRUCTIONS
Using a laundry tub
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from the
end of the drain hose. If the drain hose is extended more than
4 inches (10 cm) beyond the end of the elbow bracket, mold,
or microorganisms could spread to the inside of the washer.
No more than
4 inches (10 cm)
2 Hang the end of the drain hose over the side of the laundry tub.
3
Use a tie strap to secure the drain hose in place.
15
Drain Hose