Publicidad
Idiomas disponibles
Idiomas disponibles
( 4 )
Fridge/
The Fridge button serves two purposes:
Power
- To set the Fridge to your desired
Cool
temperature.
(3sec)
- To turn the Power Cool function on
1) To set the Fridge temperature, press
the Fridge button. You can set the
2) Power Cool function
Touch and hold this button for 3 seconds
to decrease the time needed to cool
products in the Refrigerator. It can be
helpful if you need to quickly cool easily
spoiled items or if the temperature in
the fridge has warmed dramatically (for
example, if the door was left open).
( 5 )
Lighting/
The Lighting button serves two purposes:
ºC ↔ ºF
-
(3sec)
- To switch the temperature units
between ºC and ºF
1) Light Function
Touching the Lighting button turns on
the Dispenser LED lamp in continuous
mode so that it stays on continuously.
The button also lights up. If you want the
Dispenser lamp to come on only when
some one uses the dispenser, press the
Lighting button to turn the continuous
2) To switch the temperature units
between ºC and ºF
Touch and hold this button for 3 seconds
to select the temperature display you
want.
Each time you press and hold the button,
the ºC and ºF temperature modes
alternate and the ºC or ºF icon lights up,
indicating your selection.
DA68-02601G-00.indb 19
( 6 )
Ice Maker
purposes:
Control
-
Lock
- To turn the Control Lock Function on
(3sec)
1)
If you don't want to make more ice, press
2) Control Lock Function
Touch and hold this button for 3 seconds
to lock the display, the Flex Zone panel,
and the dispenser buttons so the buttons
can not be used.
When Control Lock is on, the refrigerator
does not dispense ice or water, even if the
Dispenser Lever is pressed.
The Control Lock icon lights up to
indicate you've activated the Control Lock
function. Press 3 seconds to unlock.
(7)
Water
Touch this button to dispense water. This
mode can not be used with the Ice Type
mode simultaneously.
Cubed/Crushed Ice button.
(8)
Water filter usage
Filter
This icon lights up when you need to
change the filter, usually after the
refrigerator has dispensed about 300
gallons of water (after about 6 months).
The icon will blink red for several seconds
when you open or close the door.
After you install the new water filter, reset
the filter indicator by touching and holding
3sec for Filter Reset button for 3 seconds.
- If water is not dispensing or
- Some areas have large amounts
( 9 )
Ice Type
Touch this button to select your desired
ice type. Cubed and crushed ice modes
alternate when you press the button. This
mode can not be used with the Water
mode simultaneously.
English - 19
dispensing slowly, you need to
replace the water filter because
the water filter is clogged.
of lime in their water, which
causes the water filter to clog
more quickly.
2014. 12. 4.
3:05
Publicidad
